Current Position:Home -> Technology -> Content
Stretch film wrapping machine common faults and solutions
Source:本站原创 Posttime:2010-2-4 10:03:29
Problem |
Possible Cause |
Solution |
Stretch film wrapping machine just starts without action |
1. power is not connected |
Check external power supply, re-transmission |
2. control power is not connected |
With the key switch to turn on the power distribution cabinet, or close the switch | |
3. Press the pause button |
Then click and let it bounce | |
4. Press the emergency button |
Release emergency stop button | |
5. PLC Damage |
change | |
6. Power lines and other equipment |
Connect independent power | |
Stretch film wrapping machines Turntable does not turn |
1. Inverter burned, the phenomenon is no display |
change |
2. Inverter parameters set wrong |
Reset the parameter | |
3. Turntable chain broke |
Adjust the size of the distance between the sprocket, chain link, if it is damaged then replace the chain chain | |
4. Turntable motor itself Fault |
Shaking table test with the multimeter, or whether the missing items or electrical breakdown, if the site can not repair, then replace the motor | |
5. Rotary reducer own fault |
Replace | |
6. Knob is damaged, the chassis will not be diverted (E-type equipment) |
Replace | |
7. PLC does not outout |
Replace | |
8. Turntable gear and sprocket connection is not normal |
Replace connect button | |
Turntable should be pushed to start |
1. Inverter delay is set to start from the start-up time is too long |
reset |
Turntable continue to run |
2.DIP switch is damaged |
Maintenance DIP Switch |
Turntable can not be slow, the slow stop |
1. Inverter parameter set wrong |
reset |
turning up the wheel with noiseafter |
1. Uneven ground |
Require users to organize or replacement or location |
2. some Individual roller serious wear and tear |
Replace the roller | |
Inverter overload alarm display |
Voltage instability |
Adjust the frequency to improve the power quality or acceleration and deceleration time |
Active rubber roller, film frame connectors (square poles) damage |
1damage in transit |
Replace |
2. Artificially damaged |
Replace | |
Film frame rate can not adjust |
1. DC converter box is damaged, no output |
Replace |
2. Individual tray round of serious wear and tear |
Replace the roller |